The "Light Up The Night" decal is designed to be activated at night time hours.  It is activated by the use of a simple headlight or other manually activated switch. 

At night hours, your decal will attract the attention of everyone around you, because of it's unique luminescent properties.  Our decal is visible during the day just like any other decal out there, but we go beyond the "other decals" and truly "Light Up The Night"!

Pleas note that the ultraviolet light from the sun can reduce the luminescent capabilities and shorten the life span of the luminescent properties of the decal, so we encourage you to activated it only during nighttime hours.  The decal is visible during the day without the switch being on.  The standard luminescent life span of the decal is approximately 3000 hours when  installed properly.

Simple Installation Instructions:

  1. Remove adhesive cover from face of decal and press decal firmly to inside of glass area. 
     
  2. Locate positive and negative wiring which is controlled by the headlight switch (taillight or license plate lamp is recommended)  If vehicle is equipped with daytime driving lights, alternate electrical wiring should be used.
     
  3. Once wiring is located, use wire nuts, butt splices, or other approved means of splicing and connecting wiring.
     
  4. Connect white and black wires from inverter to decal/lamp using the latch female and male plastic connectors.
     
  5. Secure inverter in some fashion to prevent strain on electrical connections.

 

 

Questions or comments about this site go to sanddinnovations@att.net
Copyright © 2007  S&D Innovations, Inc  All rights reserved.
407.865.3006 - Geneva, FL